pasterwriters.blogg.se

1. #CISCO SWITCH RIGHT TO USE LICENSE HOW TO#
2. #CISCO SWITCH RIGHT TO USE LICENSE ACTIVATION KEY#
3. #CISCO SWITCH RIGHT TO USE LICENSE SERIAL NUMBER#

There are two main types of Cisco Catalyst 3850 license: permanent RTU license and evaluation RTU license.What are the different types of licenses in the Cisco Catalyst 3850?.

While placing the order, the customer specifies the license requirement and receives an electronic license or paper license for entitlement purpose only. Cisco Catalyst 3850 switches use a trust-based RTU licensing model. No PAK is required for software licensing in Cisco Catalyst 3850 switches.

#CISCO SWITCH RIGHT TO USE LICENSE ACTIVATION KEY#

#CISCO SWITCH RIGHT TO USE LICENSE HOW TO#

And that is how licensing works.I cant see exactly what you got so all i can provide are the options on the docs that show how to activate it, this below shows the same commands as above to use and in this doc as well it goes through how to activate a non pak code licenses exactly have you tried following the doc ? Whats happening when you try to activate it We can see here that there is an IP Services license available for evaluation if we need to do that. License State: Active, Not in Use, EULA not accepted UDI=WS-C3560X-24T-L:$PAKNR StoreIndex=1:Primary License StorageĪfter the reboot we can use show license to see what licenses are installed: *Mar 1 00:07:42.539: %LICENSE-6-INSTALL: Feature ipbase 1.0 was installed in this device.

*Mar 1 00:07:42.279: %IOS_LICENSE_IMAGE_APPLICATION-6-LICENSE_LEVEL: Module name = c3560x Next reboot level = ipbase and License = ipbase We will also get a message logged to the console that looks like this: The license is now installed but we need to reboot the switch before it goes active. Installing…Feature:ipbase…Successful:Supported Installing licenses from “flash:filename.lic” Switch#license install flash:filename.lic After that we need to install the license, the syntax is license install: I used FTP to upload the file:Ĭopy ftp://user: /filename.lic flash:Īccessing ftp://user: /filename.lic…ġ152 bytes copied in 0.092 secs (12522 bytes/sec) You will need to upload this file to the switch. lic file whic is a combination of the PAK number, a date and some other numbers. When the registration is done you will receive a.

#CISCO SWITCH RIGHT TO USE LICENSE SERIAL NUMBER#

The product number can be WS-C3560X-24T-L and the serial number is a string of letters and numbers, the same goes for the PAK number. You also need to now the productnumber and the serial number for the device that the license is for. To get the licenses you need to register your Product Activation Key (PAK) that you receive after ordering the license. The universal image has a name like this:. I did an upgrade from LAN Base to IP Base and thought it would be a good idea to show how it’s done. With the new switches like 3560-X it is possible to run a universal IOS image with support for different feature sets like LAN Base, IP Base and IP Services where IP services is the most feature rich version.